Some of the links and information provided in this thread may no longer be available or relevant.
If you have a question please post a new topic.
- Mark as New
- Bookmark
- Subscribe
- Subscribe to RSS Feed
- Permalink
- Email to a Friend
- Report Inappropriate Content
Cordless Phone Setup
Prior to our DOT installation we had purchased 2x Uniden cordless phones to use in the factory. We can transfer to the cordless phones from the Cisco phone and we can also answer an incoming call on the Uniden cordless phones. We are unable to make any externals call from the Uniden cordless phones.
We have tested the phone port by plugging in an older telstra phone and this phone can receive incoming and make outgoing calls therefore the ports are all ok.
Any ideas?
Was this helpful?
- Yes it was, thank you
- No, I still need help
Thank you for your feedback
Thank you for your feedback
- Mark as New
- Bookmark
- Subscribe
- Subscribe to RSS Feed
- Permalink
- Email to a Friend
- Report Inappropriate Content

Re: Cordless Phone Setup
Hi JC11.
That is strange. If it can receive calls you would expect it to be able to make calls. Have you tried speaking with Uniden support to see if there is anything they can suggest?
Need help? Check out our Community Wiki or Support Portal || Looking for a new mobile? Order online today || Get help with any Tech at Home with Telstra Platinum || Don't forget to tag answers as Accepted Solutions and give a Like to the member(s) who helped you out.
All moderation actions are supported by the CrowdSupport Community Guidelines
Related Content
-
Cordless phones for DOT/NBN IP
Find out more -
Unreliable SPA504G operation with Cisco RV220W router
Find out more